Overview
DoorKing traffic control spikes help enforce one-way vehicle flow through controlled entrances, parking facilities and secured access lanes. Available configurations include flush in-ground systems and surface-mount spike sections, along with illuminated warning signage for approaching drivers.
Traffic speed must be controlled before vehicles cross the spikes. DoorKing specifies a maximum crossing speed of 5 MPH and requires appropriate warning signs and speed-control measures as part of the traffic spike installation.
Available Products
DoorKing 1610-081 6 ft. Flush-Mount Weighted Traffic Spikes
Six-foot flush in-ground traffic spike section with independently counterweighted spikes. The galvanized steel housing and red top plate provide a durable, highly visible one-way traffic control system without spring-loaded spike operation.
DoorKing 1610-082 6 ft. Flush-Mount Spring-Loaded Traffic Spikes
Six-foot flush-mount system with individually spring-loaded spikes. Includes a speed bump and lock-down mechanism that can secure the spikes in the retracted position when temporary two-way traffic is required.
DoorKing 1610-087 3 ft. Surface-Mount Spike Extension
Three-foot modular extension for compatible DoorKing surface-mount traffic spike systems. Spring-loaded spikes and stainless steel springs provide one-way traffic control, while the raised housing also functions as a speed-control feature.
DoorKing 1610-088 3 ft. Surface-Mount Spike Assembly
Complete three-foot surface-mount spike assembly with spring-loaded spikes and two end caps. Designed for installation on an even concrete surface at controlled low-speed one-way vehicle entrances.
DoorKing 1615-080 Illuminated Traffic Control Warning Sign
Illuminated warning sign for use with DoorKing traffic spike systems. Red and green signals provide vehicle instructions, while an automatic light sensor activates illumination in low-light conditions.
Flush-Mount vs. Surface-Mount Spikes
Flush-mount systems are installed below the roadway surface and are available with weighted or spring-loaded spike retraction. These six-foot sections provide a lower-profile installation across the controlled traffic lane.
Surface-mount spikes install directly to a suitable concrete surface without trenching. Three-foot sections can be combined for the required lane width, and the raised housing also helps slow approaching vehicles.
Low-Speed One-Way Traffic Control
DoorKing traffic spikes are designed to enforce one-way traffic in controlled access lanes. They are not intended for uncontrolled roadways or locations where vehicles approach at normal driving speeds.
Vehicle speed must be reduced to 5 MPH or less before crossing the spikes. Warning signs and speed-control measures should be positioned so drivers clearly understand the lane direction and spike installation before entering the controlled area.
Installation and Safety
Traffic spike systems should be installed perpendicular to the direction of vehicle travel so vehicles cross the spikes at approximately 90 degrees. Surface-mount components should be anchored to a suitable concrete surface according to the installation requirements.
DoorKing cautions against using traffic spikes in areas subject to freezing weather where snow or ice can accumulate. The manufacturer also notes that tire construction varies, so the spikes cannot be guaranteed to penetrate every tire.
Selection Assistance
Barron Equipment offers DoorKing traffic spike systems for controlled commercial, parking and access-control lanes. Select flush-mount spikes when an in-ground installation is preferred, or surface-mount sections when trenching is not practical.
Before installation, verify traffic direction, lane width, vehicle types, approach speed, concrete mounting conditions and warning requirements. These systems are intended for automotive and light pickup traffic in properly controlled lanes.

















