Overview
The lower portion of garage door side weather stripping is one of the most common points where rodents chew their way into a garage. Standard rubber and vinyl molding offers little resistance to mice, rats, and chipmunks that gnaw through the seal material to access the interior. The Xcluder RodentBLOCK Garage Door Rodent Shield Kit provides a targeted solution — a pre-cut stainless steel barrier that adheres directly to the inside of the existing side seal, reinforcing the area where rodent damage is most likely to occur.
Each shield is made from high-quality stainless steel with an adhesive backing that bonds to the inner surface of the weather stripping. The shields mount on the inside of the seal so they are not visible from outside the garage, and installation requires no tools — simply clean the surface, peel off the backing, and press the shield into place. Available in multiple pack sizes, this kit is designed for both residential and commercial garage door applications where fast, effective rodent exclusion is needed without replacing the entire side seal.
Features and Construction
Each rodent shield measures 8 inches long by 1 inch wide and is constructed from corrosion-resistant stainless steel. The material is chosen specifically because rodents cannot chew through it, and stainless steel will not rust or degrade over time — even in wet, humid, or temperature-variable garage environments. The adhesive backing is pre-applied to each shield, so no screws, rivets, or special fasteners are needed.
The shields are designed to cover the bottom section of the garage door side weather stripping on both sides of the door, creating a durable physical barrier right at the point where rodents are most likely to attempt entry. Because they install on the inside surface of the seal, the shields remain hidden from view and do not affect the appearance of the door from the exterior. Each kit includes an alcohol wipe and installation instructions to ensure a clean, secure bond.
Applications
The rodent shield kit is designed for residential and commercial garage doors that use molding-style or insulation-style side weather stripping. It is especially effective for garages in areas with high rodent pressure, including rural properties, buildings near food sources, and facilities where chemical pest control is not practical or preferred. The shields provide a fast, affordable first line of defense at a known vulnerability point without the cost or labor of a full side seal replacement.
For garages that need more comprehensive protection, the rodent shield kit can be paired with other Xcluder products including RodentBLOCK bottom seals, fill fabric, and vertical side seal kits to close every potential entry point around the full door perimeter.
Available Pack Sizes
- XRS-02 — 2-Pack: Includes 2 stainless steel rodent shields (one per side for a single garage door), alcohol wipe, and installation instructions
- XRS-04 — 4-Pack: Includes 4 shields for covering both sides of two garage doors
- XRS-24 — Bulk Pack: Includes 24 shields for multi-door installations, property management, or contractor inventory
Each shield is pre-cut to size and does not require measuring or trimming before installation.
Selection Assistance
The rodent shield kit addresses the side seal entry point — one of the most common but often overlooked areas where rodents gain access. If your garage door also has gaps at the bottom, around the threshold, or along the top header, additional Xcluder products may be needed for full perimeter protection. Barron Equipment can help you assess your garage door setup and recommend the right combination of rodent exclusion products for your property or facility.
Request a quote below or contact us directly to discuss your garage door rodent proofing needs.